125Khz / 13.56Mhz Access Control System Standalone Pin Card EM/IC
Main products are the access control RFID reader, offline or TCP/IP
network Access Controller, related access control products. Along
with the RFID Cards, special mini cards, Smart label, RFID Tags,
NFC tag, Also we have special trading business on the Animal
Identification, like the Glass tag(microchip), ear tag, comply with
Benefits of the reader:
- When the card approach the reader, the red light turn into green,
after glinting to turn redcolor again, the buzzer sound shows
transiting data. It has 500ms proximity time distance for card
proximity. After finishing card proximity, if the same ID card is
still in the proximity range, reader will not send out the data,
neither giving any sound hint. But for Different ID card entering
Proximity Area, Reader can do response continually and send out the
Notice of the reader:
- Confirm the electric voltage (DC12V) and differentiate positive
anode and cathode of power supply.
- When external Power is used, make sure sharing the power with
Controller Box or using the same GND.
- When the distance between card reader and controller is more than
50m, please use Power Line with at least 1.5 square cm Dia, or
using several parallel Network wires.
Product Parameter of card reader
|Support||125KHz EM ID|
|13.56MHz MF IC|
|Communication Distance||The weigand 100m|
|Built-in||Antenna,speaker,buzzer,red(bule)green color LED|
|Speical Provide||Logo printing,long cable,Reader module,Daul frequency(ID&IC)|
For access control ,attendance,fees,patrol,card,building onsay,
parking systems, highways and rfid application.
This series of reader with high sensitivity receiver,small
current,single DC power supply,low price,and high reliability.
Using + type screw driver to loosen the screw between the panel
and motherboard. And then embed the motherboard to the side wall
the plastic plug and screws.
|Wire Connection||Red DC 5V-16V|
1. Confirm the electric voltage (DC12V) and differentiate positive
anode and cathode of power supply
2. When external Power is used, make sure sharing the power with
Controller Box or using the same GND
3. When the distance between card reader and controller is more
please use Power Line with at least 1.5 square cm Dia, or using
parallel Network wires